The SSH Access parameter is disabled by default. You must enable the SSH Access parameter before users
of these phones can use SSH.
Procedure
Step 1
In Cisco Unified Communications Manager Administration, choose one of the following windows:
•
Device > Device Settings > Common Phone Profile
•
Device > Phone > Phone Configuration
If you set the parameter in both windows, the setting in the Device > Phone > Phone Configuration
window takes precedence.
Note
Step 2
Select the appropriate phones.
Step 3
Scroll to the Product Specific Configuration Layout pane and select Enable from the SSH Access drop-down
list box.
Step 4
Select Save.
Set Up Call Forward Notification
You can control the call forward settings.
Procedure
Step 1
In Cisco Unified Communications Manager Administration, select Device > Phone.
Step 2
Locate the phone to be set up.
Step 3
Configure the Call Forward Notification fields.
DescriptionField
When this check box is checked, the caller name displays in the notification
window.
By default, this check box is checked.
Caller Name
When this check box is checked, the caller number displays in the notification
window.
By default, this check box is not checked.
Caller Number
When this check box is checked, the information about the caller who last
forwarded the call displays in the notification window.
Example: If Caller A calls B, but B has forwarded all calls to C and C has
forwarded all calls to D, the notification box that D sees contains the phone
information for caller C.
By default, this check box is not checked.
Redirected Number
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
222
Set Up Call Forward Notification
To Next Page
Loading...
Need help?
General
