Procedure
Step 1
Press Applications .
Step 2
To access the Network Settings menu, select Administrator Settings > Network Settings
Related Topics
Network Protocols, on page 9
Status Messages Fields, on page 265
Set Up IPv4
The following table describes the IPv4 Setup menu options.
Table 12: IPv4 Setup Menu Options
To changeDescriptionOption
See Set DHCP Enabled Field,
on page 82.
Indicates whether the phone has DHCP enabled or
disabled.
When DHCP is enabled, the DHCP server assigns
the phone an IP address. When DHCP is disabled,
the administrator must manually assign an IP
address to the phone.
For more information, see Set Up Phone To Use
DHCP, on page 84 and Set Up Phone To Not Use
DHCP, on page 85.
DHCP Enabled
See Set IP Address Field, on
page 82.
Internet Protocol (IP) address of the phone.
If you assign an IP address with this option, you
must also assign a subnet mask and default router.
See the Subnet Mask and Default Router options
in this table.
IP Address
See Set Subnet Mask Field, on
page 83.
Subnet mask used by the phone.Subnet Mask
See Set Default Router Field,
on page 83.
Default router used by the phone.Default Router
See Set DNS Server Fields, on
page 83.
Primary Domain Name System (DNS) server (DNS
Server 1) and optional backup DNS servers (DNS
Server 2 and 3) that the phone uses.
DNS Server 1
DNS Server 2
DNS Server 3
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
73
Configure Network Settings