Cisco 9971 - Enable Privacy Settings

Procedure
Step 1
Configure the phones and users.
Step 2
Associate the phones to the users.
Step 3
Activate the Cisco IP Manager Assistant service in the Service Activation window.
Step 4
Configure system administration parameters.
Step 5
If required, configure IPMA clusterwide services parameters.
Step 6
(Optional) Configure the user CAPF profile
Step 7
(Optional) Configure the IPMA service parameters for security
Step 8
Stop and restart the IPMA service.
Step 9
Configure phone parameter, manager, and assistant settings, including the softkey templates.
Step 10
Configure Cisco Unified Communications Manager Assistant application.
Step 11
Configure dial rules.
Step 12
Install the Assistant Console application.
Step 13
Configure the manager and assistant console applications.
Enable Privacy Settings
You can control the information displayed on the assistant phone and in the assistant phone log for private
manager calls using the parameters: Show Remote Private Calls and Record Call Log for Remote Private
Calls.
When Privacy is turned on for the manager phone and the Show Remote Private Calls is enabled on the
assistant, the assistant phone shows “Private” instead of the caller information for private calls on the manager
phone. When Privacy is turned on for the manager phone and the Show Remote Private Calls is disabled on
the assistant phone, the assistant phone does not display any call session information about private calls on
the manager phone. In this case, the assistant phone displays the solid red LED for the shared line.
By default, Show Remote Private Calls is disabled.
When Privacy is turned on for a call and Record Call Log for Remote Private Calls are enabled, the call log
for the assistant phone shows the call information for the private call on the manager phone. When Privacy
is turned on for a call and Record Call Log for Remote Private Calls is disabled, the call log for the assistant
phone does not store call information for private calls on the manager phone.
Procedure
Step 1
In the Cisco Unified Communications Manager Administration window, select Device > Phone.
Step 2
To show “Private” on the manager's private call on an assistant phone, enable the Show Remote Private Calls
field for the assistant phone.
Step 3
To log a manager's private calls on an assistant phone, enable Record Call Log for Remove Private Calls for
the assistant phone.
Step 4
Click Save.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
246
Enable Privacy Settings