EasyManuals Logo

Cisco 9971 Administration Guide

Cisco 9971
352 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
Administration, to provide wireless voice communication. Cisco Access Points can run in standalone or unified
mode. Unified mode requires the Cisco Unified Wireless LAN Controller.
The Cisco Unified IP Phone 9971 exhibits Wi-Fi capabilities which can be used with 802.11a, 802.11b, and
802.11g Wi-Fi.
The following figure shows a typical WLAN topology that enables the wireless transmission of voice for
wireless IP telephony.
Figure 1: WLAN with Wireless IP Phones
Cisco Unified Wireless AP Requirements
APs are critical components in a WLAN because they provide the wireless links or " hot spots " to the network.
When a Cisco Unified IP Phone powers on, it searches for and becomes associated with an access point (AP)
if the phone wireless access is set to On. The Cisco Unified IP Phone scans for APs with SSIDs and encryption
types that it recognizes. The phone builds and maintains a list of eligible APs and uses the following variables
to determine the best AP:
•
Received Signal Strength Indicator (RSSI): Signal strength of available APs within the RF coverage
area. The phone attempts to associate with the AP with the highest RSSI value and lowest channel usage
values (QBSS) that possess matching SSID and encryption types.
•
Traffic Specification (TSpec): Calculation of call limits and WLAN load balancing. The TSpec value
of each voice stream allows the system to allocate bandwidth to voice devices on a first-come, first-served
basis.
APs transmit and receive RF signals over channels within the 2.4 GHz or 5 GHz frequency band. To provide
a stable wireless environment and reduce channel interference, you must specify nonoverlapping channels
for each AP. The recommended channels for 802.11b and 802.11g in North America are 1, 6, and 11.
In a non-controller-based wireless network, we recommend that you statically configure channels for each
AP. If your wireless network uses a controller, use the Auto-RF feature for minimal voice disruption.
Note
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
44
VoIP Wireless Network Components

Table of Contents

Other manuals for Cisco 9971

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 9971 and is the answer not in the manual?

Cisco 9971 Specifications

General IconGeneral
Resolution640 x 480 pixels
Programmable Line Keys5
ProtocolsSIP, SCCP
Wi-Fi802.11a/b/g
Weight3.5 lbs
Display5-inch color LCD
AudioWideband audio, G.722 codec support
USB Ports2 x USB 2.0
Ethernet Ports2
PoEYes (802.3af)
VideoH.264
Network Interfaces10/100/1000 Ethernet
CodecsG.711, G.722, G.729a, G.729ab, iLBC
Power OptionsPoE
Headset PortDedicated headset port
SpeakerphoneFull-duplex speakerphone

Related product manuals