Procedure
Step 1
Press Applications .
Step 2
To access the Network Settings menu, select Administrator Settings > Network Settings
Step 3
To access the IPv4 settings menu, perform one of the following actions:
•
For Cisco Unified IP Phones 8961 and 9951: navigate to the IPv4 options from Ethernet Setup > IPv4
Setup.
•
For Cisco Unified IP Phone 9971 with Wi-Fi disabled on the Cisco Unified Communications Manager:
navigate to the Ethernet IPv4 options from Ethernet Setup > IPv4 Setup.
•
For Cisco Unified IP Phone 9971 with Wi-Fi enabled on the Cisco Unified Communications Manager:
navigate to Wireless Setup > IPv4 Setup.
Set Up IPv6
IPv6 addressing is supported on the phone. A valid IPv6 address is 128 bits in length, including the subnet
prefix.
IPv6 addresses must be in one of the following formats:
•
Eight sets of four hexadecimal digits separated by colons where the leftmost digits represent the
highest-order bits. Any leading or trailing zeros in each group may be omitted.
•
Compressed format to collapse a single run of consecutive zero groups into a single group represented
by a double colon. Note that this can only be done once in an address.
Before IPv6 setup options can be configured on your device, IPv6 must be enabled and configured in Cisco
Unified Communication Administration. The following device configuration fields apply to IPv6 configuration:
•
IP Addressing Mode
•
IP Addressing Mode Preference for Signalling
If IPv6 is enabled in the Unified cluster, the default setting for IP addressing mode is IPv4 and IPv6 (dual-stack).
In this addressing mode, the phone will acquire and use one IPv4 address and one IPv6 address. It can use
the IPv4 and the IPv6 address as required for media. The phone uses either the IPv4 or IPv6 address for call
control signalling to Unified CM.
For more information, see the section on Common Device Configuration in Cisco Unified Communications
Manager Feature and Services Guide, “IPv6 Support in Cisco Unified Communications Devices”.
Cisco recommends IPv4 and IPv6 as the setting for the phone addressing mode. IPv6 Only is not
recommended for production environments.
Note
You set up IPv6 from one of the following menus:
•
On all phones: Ethernet Settings > IPv6 Setup
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager
10.0
76
Configure Network Settings
To Next Page
Loading...
Need help?
General
