d) Select Save.
Step 2
To configure Automatic Port Synchronization for a group of phones,
a) In the Cisco Unified Communications Manager Administration application, choose System > Enterprise
Phone Configuration.
b) Set the Automatic Port Synchronization parameter.
c) Select Save.
Set Up Bluetooth Profiles
For more information on Bluetooth profiles, see the documentation for your particular Cisco Unified
Communications Manager release.
Procedure
Step 1
In Cisco Unified Communications Manager Administration, choose Device > Phone.
Step 2
Find your phone from the list of phones that display in Cisco Unified Communications Manager.
Step 3
Click on the Device Name of the phone.
The Phone Configuration window appears.
Step 4
Go to the Product Specific Configuration Layout area and from the Bluetooth Profiles drop-down list, choose
the applicable profile.
The Handsfree profile is selected by default.
Step 5
Check the Override Common Settings check box for any setting in the Product Specific Configuration area
that you wish to update.
•
If you do not check this check box, the corresponding parameter setting does not take effect.
•
Parameters that you set in the Product Specific Configuration area may also appear in the Device
Configuration window for various devices and in the Enterprise Phone Configuration window.
If you also set these same parameters in these other windows, the setting that takes precedence is determined
in the following order:
1
Device Configuration window settings (highest precedence)
2
Common Phone Profile Configuration window settings
3
Enterprise Phone Configuration window settings (lowest precedence)
Set Up SSH Access
You can enable or disable access to the SSH daemon through port 22. Leaving port 22 open leaves the phone
vulnerable to Denial of Service (DoS) attacks. By default, the SSH daemon is disabled.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 10.0
221
Set Up Bluetooth Profiles
To Next Page
Loading...
Need help?
General
