Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring Device Security
Defining Access Control
Cisco Small Business SFE/SGE Managed Switches Administration Guide 97
4
- MAC Address — Matches the source MAC address from which packets
are addressed to the ACE.
- Wildcard Mask — Indicates the source MAC Address wildcard mask.
Wildcards are used to mask all or part of a source MAC Address.
Wildcard masks specify which octets are used and which octets are
ignored. A wildcard mask of ff:ff:ff:ff:ff:ff indicates that no octet is
important. A wildcard of 00:00:00:00:00:00 indicates that all the octets
are important. For example, if the source MAC address
09:00:07:A9:B2:EB and the wildcard mask is 00:ff:00:ff:00:ff, the 1st, 3rd,
and 5th octets of the MAC address are checked, while the 2nd, 4th, and
6th octets are ignored.
• Destination MAC Address
- MAC Address — Matches the destination MAC address to which
packets are addressed to the ACE.
- Wildcard Mask — Indicates the destination MAC Address wildcard
mask. Wildcards are used to mask all or part of a destination MAC
Address. Wildcard masks specify which octets are used and which
octets are ignored. A wildcard mask of ff:ff:ff:ff:ff:ff indicates that no octet
is important. A wildcard of 00:00:00:00:00:00 indicates that all the octets
are important. For example, if the destination MAC address
09:00:07:A9:B2:EB and the wildcard mask is 00:ff:00:ff:00:ff, the 1st, 3rd,
and 5th octets of the MAC address are checked, while the 2nd, 4th, and
6th octets are ignored.
• VLAN ID — Matches the packet’s VLAN ID to the ACE. The possible field values
are 1 to 4095.
• Inner VLAN — Matches the ACE to the inner VLAN ID of a double tagged
packet.
• 802.1p — Displays the packet tag value.
• 802.1p Mask — Displays the wildcard bits to be applied to the CoS.
• Ethertype — Displays the Ethernet type of the packet.
• Action — Indicates the ACL forwarding action. The possible field values are:
- Permit — Forwards packets which meet the ACL criteria.
- Deny — Drops packets which meet the ACL criteria.
- Shutdown — Drops packet that meet the ACL criteria, and disables the
port to which the packet was addressed.

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x