Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring Device Security
Defining DHCP Snooping
Cisco Small Business SFE/SGE Managed Switches Administration Guide 138
4
• Status — Indicates if IP Source Guard is enabled or disabled.
- Enabled — Indicates that IP Source Guard is enabled on the interface.
- Disabled — Indicates that IP Source Guard is disabled on the interface.
This is the default value.
STEP 2 Click Edit. The Edit Interface Settings Page opens:
Edit Interface Settings Page
STEP 3 Modify the fields.
STEP 4 Click Apply. The new IP Source Guard Interface configuration is added, and the
device is updated.
Querying the IP Source Binding Database
The IP Source Guard Binding Database Page enables network managers to query
and view information about inactive addresses recorded in the DHCP Database.
To query the IP Source Guard Database:

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x