Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring Ports
Cisco Small Business SFE/SGE Managed Switches Administration Guide 160
5
- 1000M — ComboC (combo port with copper cable 3).
- 1000M — ComboF (combo port with optic fiber cable).
- Fiber — Indicates the port has a fiber optic port connection.
• Admin Status — Enables or disables traffic forwarding through the port.
• Current Port Status — Displays the port connection status.
• Reactivate Suspended Port — Reactivates a port if the port has been disabled
through the locked port security option or through Access Control List
configurations.
• Operational Status — Indicates whether the port is currently active or inactive.
• Admin Speed — Displays the configured rate for the port. The port type
determines what speed setting options are available. You can designate admin
speed only when the port auto-negotiation
is disabled.
• Current Port Speed — Displays the current port speed.
• Admin Duplex — Defines the port duplex mode. This field is configurable only
when auto negotiation is disabled, and the port speed is set to 10M or 100M.
This field cannot be configured on LAGs. The possible field values are:
- Full — Indicates that the interface supports transmission between the
device and the client in both directions simultaneously.
- Half — Indicates that the interface supports transmission between the
device and the client in only one direction at a time.
• Current Duplex Mode — Displays the port current duplex mode.
• Auto Negotiation — Enables Auto Negotiation on the port. Auto Negotiation
enables a port to advertise its transmission rate, duplex mode and flow control
abilities to its partner.
• Current Auto Negotiation — Displays the Auto Negotiation status on the port.
• Admin Advertisement — Specifies the capabilities to be advertised by the
Port. The possible field values are:
- Max Capability — Indicates that all port speeds and Duplex mode
settings can be accepted.
- 10 Half — Indicates that the port is advertising a 10 mbps speed and
half Duplex mode setting.

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x