Configuring IP Information
IP Addressing
Cisco Small Business SFE/SGE Managed Switches Administration Guide 196
7
- Reachable — Indicates that a positive confirmation was received within
the last Reachable Time.
- Stale — Indicates that the previously known neighbor is no longer
reachable. No action is taken to verify its reachability, until traffic needs
to be sent.
- Delay — Indicates previously known neighbor is no longer reachable.
Device is in Delay state for a predefined Delay Time that if no
reachabiltiy confirmation is received, the state changes to Probe.
- Probe — Indicates the neighbor is no longer reachable, and unicast
Neighbor Solicitation probes are being sent to verify reachability.
STEP 2 Click the Add button. The
Add Static Default Gateway Page opens:
The
Add Static Default Gateway Page
provides information for adding a static
Default Gateway.
Add Static Default Gateway Page
The Add Static Default Gateway Page contains the following fields:
• Supported IP Format — Indicates the supported IP version is IPv6.
• IPv6 Address Type — Indicates the IPv6 address is link local IP address, that
uniquely identifies hosts on a single network link. A Link-local address has a
prefix of ‘FE80’. The link-local addresses are not routable and can be used for
communication on the same network only.
• Link Local Interface — Indicates the Link Local Interface. The possible field
values are:
- VLAN — Indicates the VLAN is the Link local interface.
To Next Page
Loading...
