Configuring IP Information
IP Addressing
Cisco Small Business SFE/SGE Managed Switches Administration Guide 198
7
STEP 1 To define an IPv6 ISATAP tunnel: Click > System > System Management > IP
Addressing > IPv6 Configuration > ISATAP Tunnel. The
ISATAP Tunnel Page
opens:
ISATAP Tunnel Page
The
ISATAP Tunnel Page
contains the following fields:
• ISATAP Status — Enables IPv6 over IPv4 ISATAP tunneling. Once ISATAP is
enabled, an ISATAP interface is created. The possible field values are:
-
Enable
— Enables ISATAP tunnel on the device.
-
Disable
— Disables ISATAP tunnel on the device. This is the default
value.
• Tunnel Router's Domain Name
—
Specifies a global string that represents a
specific automatic tunnel router domain name. The default value is ISATAP.
-
Use Default
—
Selecting the check box that returns settings to default.
• Query Interval (10-3600)
—
Specifies the interval between DNS Queries
(before the IP address of the ISATAP router is known) for the automatic tunnel
router domain name. The range is 10 - 3600 seconds. The default is 10
seconds.
-
Use Default
—
Selecting the check box that returns settings to default.
To Next Page
Loading...
