Configuring Quality of Service
Defining Advanced QoS Mode
Cisco Small Business SFE/SGE Managed Switches Administration Guide 292
11
STEP 4 Click Apply. The Aggregate policer is added, and the device is updated.
Modifying QoS Aggregate Policer
STEP 1 Click Quality of Service > Advanced Mode > Aggregate Policer. The
Aggregate
Policer Page
opens:
STEP 2 Click the Edit Button. The
Edit QoS Aggregate Policer Page
opens:
Edit QoS Aggregate Policer Page
The
Edit QoS Aggregate Policer Page
contains the following fields.
• Aggregate Policer Name— Specifies the Aggregate Policer Name
• Ingress Committed Information Rate (CIR) — Defines the CIR in bits per
second.
• Ingress Committed Burst Size (CS) — Defines the CS in bytes per second.
• Exceed Action — Action assigned to incoming packets exceeding the CIR.
Possible values are:
-
Drop
— Drops packets exceeding the defined CIR value.
-
Remark DSCP
— Remarks packet’s DSCP values exceeding the defined
CIR value.
STEP 3 Define the relevant fields.
STEP 4 Click Apply. The device is updated.
To Next Page
Loading...
