Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring System Time
Defining System Time
Cisco Small Business SFE/SGE Managed Switches Administration Guide 34
3
STEP 1 Click System > System Management > Time > System Time. The System Time
Page
opens:
System Time Page
The
System Time Page contains the following fields:
• Clock Source — Indicates the source used to set the system clock. The
possible field values:
- Use Local Settings — The system time is set on the local device. This is
the default value.
- Use SNTP Server — Sets the system time via an SNTP server.
• Date — Indicates the system date. The field format is , for example, .
• Local Time — Indicates the system time. The field format is HH:MM:SS, for
example, 21:15:03.
• Time Zone Offset — Indicates the difference between Greenwich Mean Time
(GMT) and local time. For example, the Time Zone Offset for Paris is GMT +1,
while the local time in New York is GMT –5. There are two types of daylight
settings, either by a specific date in a particular year or a recurring setting
irrespective of the year. For a specific setting in a particular year complete the
Daylight Savings area, and for a recurring setting, complete the Recurring area.
• Daylight Savings — Enables the Daylight Savings Time (DST) on the device
based on the devices location. The possible field values are:
- USA —

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x