Cisco SGE2000 - Cisco - Gigabit Switch Administration Guide

Configuring Device Security
Defining Access Methods
Cisco Small Business SFE/SGE Managed Switches Administration Guide 71
4
- Version 6 — Indicates the device supports IPv6.
- Version 4 — Indicates the device supports IPv4.
• IPv6 Address type — Displays the IPv6 Type. The possible field values are:
- Link Local — Indicates the IPv6 address is link-local, that uniquely
identifies hosts on a single network
link. A Link-local address has a prefix of
‘FE80’. The link-local addresses are not routable and can be used for communication on
the same network only.
- Global — Indicates the IPv6 address is a global Unicast IPV6 type which
is visible and reachable from different subnets.
• Link Local Interface — Displays the VLANID on which IPv6 is configured.
• Access Profile Name — Defines the access profile name. The access profile
name can contain up to 32 characters.
• Priority — Defines the rule priority. When the packet is matched to a rule, user
groups are either granted permission or denied device management access.
The rule number is essential to matching packets to rules, as packets are
matched on a first-fit basis. The rule priorities are assigned in the Profile Rules
Page.
• Management Method — Defines the management method for which the rule is
defined. Users with this access profile can access the device using the
management method selected. The possible field values are:
- All — Assigns all management methods to the rule.
- Te l n e t — Assigns Telnet access to the rule. If selected, users accessing
the device using Telnet meeting access profile criteria are permitted or
denied access to the device.
- SNMP — Assigns SNMP access to the rule. If selected, users accessing
the device using SNMP meeting access profile criteria are permitted or
denied access to the device.
- HTTP — Assigns HTTP access to the rule. If selected, users accessing
the device using HTTP meeting access profile criteria are permitted or
denied access to the device.
- Secure HTTP (SSL) — Assigns HTTPS access to the rule. If selected,
users accessing the device using HTTPS meeting access profile criteria
are permitted or denied access to the device.

Cisco SGE2000 - Cisco - Gigabit Switch Specifications

General

Form Factor	Rack-mountable
Switching Capacity	48 Gbps
Forwarding Rate	35.7 Mpps
Layer	Layer 2
Power Supply	Internal
Management	Web-based, SNMP, CLI
MAC Address Table Size	8000 entries
VLANs	256
Features	Quality of Service (QoS), IGMP snooping, Port mirroring
Dimensions (W x D x H)	440 x 257 x 44 mm (17.3 x 10.1 x 1.73 in)
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-20 to 70°C (-4 to 158°F)
Relative Humidity	10% to 90% non-condensing
Standards Compliance	IEEE 802.3, IEEE 802.3u, IEEE 802.3ab, IEEE 802.3x