Address Table Commands 103
Syntax
•
bridge multicast address
{
mac-multicast-address
|
ip-multicast-address
}
•
bridge multicast address
{
mac-multicast-address
|
ip-multicast-address
}
[
add
|
remove
]
{
ethernet
interface-list
|
port-channel
port-channel-number-list
}
•
no bridge multicast address
{
mac-multicast-address | ip-multicast-address
}
•
add
— Adds ports to the group. If no option is specified, this is the default option.
•
remove
— Removes ports from the group.
•
mac-multicast-address
— A valid MAC Multicast address.
•
ip- multicast-address
— A valid IP Multicast address.
•
interface-list
— Separate non-consecutive Ethernet ports with a comma and no spaces; a hyphen is
used to designate a range of ports.
•
port-channel-number-list
— Separate non-consecutive port-channels with a comma and no spaces;
a hyphen is used to designate a range of ports.
Default Configuration
No Multicast addresses are defined.
Command Mode
Interface configuration (VLAN) mode.
User Guidelines
• If the command is executed without
add
or
remove
, the command only registers the group in the
bridge database.
• Static Multicast addresses can only be defined on static VLANs.
Examples
The following example registers the MAC address:
The following example registers the MAC address and adds ports statically.
Console(config)# interface vlan 8
Console(config-if)# bridge multicast address 01:00:5e:02:02:03
Console(config)# interface vlan 8
Console(config-if)# bridge multicast address 01:00:5e:02:02:03
add ethernet 1/e1-e9, 2/e2
book.book Page 103 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
