Ethernet Configuration Commands 173
Syntax
•
show interfaces configuration [ethernet
interface
|
port-channel
port-channel-number
]
•
interface
— Valid Ethernet port. (Full syntax:
unit/port
)
•
port-channel-number
— Valid port-channel number.
Default Configuration
This command has no default configuration.
Command Modes
Privileged EXEC mode.
User Guidelines
• To view information on autonegotiation capabilities, use the
show interfaces advertise
Privileged
EXEC mode command.
Example
The following example displays the configuration of all configured interfaces.
Console# show interfaces configuration
Port Type Duplex Speed Neg Flow
Ctrl
Link
State
Back
Pressure
Mdix
Mode
---- -------
----
------ ----- ------- ---- ----- -------- ----
1/e1 100M-
Copper
Full 100 Enabled Off Up Disabled Auto
1/e2 100M-
Copper
Full 100 Enabled Off Up Disabled Auto
1/e3 100M-
Copper
Full 100 Enabled Off Up Disabled Auto
1/e4 100M-
Copper
Full 100 Enabled Off Up Disabled Auto
1/e5 100M-
Copper
Full 100 Enabled Off Up Disabled Auto
1/e6 100M-
Copper
Full 100 Enabled Off Up Disabled Auto
1/e7 100M-
Copper
Full 100 Enabled Off Up Disabled Auto
book.book Page 173 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
