Port Monitor Commands 297
Command Mode
User EXEC mode.
User Guidelines
There are no user guidelines for this command.
Example
The following example shows how the port monitoring status is displayed.
console# config
console(config)# int ether 1/e2
console(config-if)# port monitor 1/e3
console(config-if)# port monitor 1/e4
console(config-if)# port monitor 1/e5
console(config-if)# port monitor 1/e6
console(config-if)# port monitor 1/e7
Too many monitoring sessions.
console(config-if)#
book.book Page 297 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
