58 Command Groups
switchport trunk native
vlan
Defines the port as a member of the specified VLAN,
and the VLAN ID is the "port default VLAN ID
(PVID)".
Interface
Configuration
switchport general
allowed vlan
Adds or removes VLANs from a general port. Interface
Configuration
switchport general pvid Configures the PVID when the interface is in general
mode.
Interface
Configuration
switchport general
ingress-filtering disable
Disables port ingress filtering. Interface
Configuration
switchport general
acceptable-frame-type
tagged-only
Discards untagged frames at ingress. Interface
Configuration
switchport forbidden
vlan
Forbids adding specific VLANs to a port. Interface
Configuration
switchport mode Configures the VLAN membership mode of a port Interface
Configuration
switchport customer
vlan
Set the port’s VLAN when the interface is in customer
mode.
Interface
Configuration
switchport protected Overrides the FDB (Forwarding Database)decision,
and sends all the Unicast, Multicast and Broadcast
traffic to an uplink port.
Interface
Configuration
map protocol
protocols-group
Maps a protocol to a protocol group. Protocol groups
are used for protocol-based VLAN assignment.
VLAN
Configuration
switchport general map
protocols-group vlan
Sets a protocol-based classification rule. Interface
Configuration
ip internal-usage-vlan Reserves a VLAN as the internal usage VLAN of an
interface.
Interface
Configuration
mac-to-vlan Adds MAC addresses to the MAC-to-VLAN database. VLAN
configuration
show vlan mac-to-vlan Displays the MAC-to-VLAN database. Privileged EXEC
show vlan Displays VLAN information. Privileged EXEC
show vlan protocols-
groups
Displays protocols-groups information. Privileged EXEC
show vlan internal
usage
Displays a list of VLANs used internally by the device. Privileged EXEC
show interfaces
switchport
Displays switchport configuration. Privileged EXEC
book.book Page 58 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
