66 Command Modes
password-aging Sets the expiration time for passwords in the local database.
passwords history Sets the number of required password changes before a password in
the local database can be reused.
passwords history hold-time Sets the number of days a password is relevant for tracking its
password history.
passwords lockout Sets the number of failed login attempts before a user account is
locked.
power inline traps enable Adds a description of the powered device type attached to the
interface.
power inline usage-threshold Configures the administrative mode of the inline power on an
interface.
priority-queue out num-of-
queues
Enables the egress queues to be SP queues.
qos Enables Quality of Service (QoS) on the device and enters QoS basic
or advance mode.
qos map dscp-queue Modifies the DSCP to CoS map.
qos trust (Global) Configure the system to "trust" state.
radius-server deadtime Improves RADIUS response times when servers are unavailable.
radius-server host Specifies a RADIUS server host.
radius-server key Sets the authentication and encryption key for all RADIUS
communications between the device and the RADIUS daemon.
radius-server retransmit Specifies the number of times the software searches the list of
RADIUS server hosts.
radius-server source-ip Specifies the source IP address used for communication with
RADIUS servers.
radius-server source-ipv6 Specifies the source IPv6 address used for the IPv6 communication
with RADIUS servers.
radius-server timeout Sets the interval for which a device waits for a server host to reply.
rmon alarm Configures alarm conditions.
rmon event Configures a RMON event.
rmon table-size Configures the maximum RMON tables sizes.
rmon table-size Configures the maximum RMON tables sizes.
show cpu utilization Enables measuring CPU utilization.
show users Changes the unit ID of a specific unit.
snmp-server community Sets up the community access string to permit access to SNMP
protocol.
book.book Page 66 Thursday, December 18, 2008 7:40 PM
To Next Page
Loading...
