AH500 Hardware and Operation Manual
6-26
(5) Set the parameters in the Driver Properties window, and then click OK.
Type a driver name in the Driver Name box.
Select USB (Virtual COM) in the Type drop-down list box in the Connection Setup section.
Select a communication port in the COM Port drop-down list box. If the first two steps are complete,
the PLC which is connected and its communication port will be displayed in the COM Port drop-down
list box.
Users can select the number of times the sending of a command is retried if a connection error occurs
in the Connect Retries box, and select an interval of retrying the sending of a command in the
Connection Time-Out box.
(6) Check if the Status of Driver is OK, if it is ok, you can close the window. COMMGR is still running in the
Windows.
To Next Page
Loading...
