Delta AH500 - Page 52

Chapter 2 Specifications and System Configuration
2-19
Number
Name
Description
10
Locating hole
A mounting clip is pressed into these locating holes.
 Profile of the redundant main backplane AHBP04MR1-5A
11
122 4 53
87 99 10
6
Number
Name
Description
1
Mounting hole
Fixing the backplane
2
Extension port 1
It is connected to a superior backplane.
3
Extension port 2
It is connected to an inferior backplane.
4
Connector
Connecting the backplane and a power supply module
5
Connector
Connecting the backplane and an input/output module
6
Mounting hole
After a module is installed, it is fixed by a screw.
7
Hole
The projection under a module is inserted into this hole.
8
Mounting clip
Hanging a backplane on a DIN rail
9
Mounting hole
After a mounting clip is installed, it is fixed by screws.
10
Locating hole
A mounting clip is pressed into these locating holes.