Delta AH500 - 13.1 Introduction of AH10 PFBS-5 A

Chapter 12 Troubleshooting
12-47
Error
code
Description Remedy
16#A801
The signal received by channel 1
exceeds the range of inputs
which can be received by the
hardware. (The ERROR LED
indicator is OFF.)
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 1 exceeds
the range of inputs which can be received by the
hardware.
16#A802
The signal received by channel 2
exceeds the range of inputs
which can be received by the
hardware. (The ERROR LED
indicator is OFF.)
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 2 exceeds
the range of inputs which can be received by the
hardware.
16#A803
The signal received by channel 3
exceeds the range of inputs
which can be received by the
hardware. (The ERROR LED
indicator is OFF.)
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 3 exceeds
the range of inputs which can be received by the
hardware.
16#A804
The signal received by channel 4
exceeds the range of inputs
which can be received by the
hardware. (The ERROR LED
indicator is OFF.)
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 4 exceeds
the range of inputs which can be received by the
hardware.
16#A805
The signal received by channel 5
exceeds the range of inputs
which can be received by the
hardware. (The ERROR LED
indicator is OFF.)
Check the module parameter in HWCONFIG.
Check whether The signal received by channel 5 exceeds
the range of inputs which can be received by the
hardware.
16#A806
The signal received by channel 6
exceeds the range of inputs
which can be received by the
hardware. (The ERROR LED
indicator is OFF.)
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 6 exceeds
the range of inputs which can be received by the
hardware.
16#A807
The signal received by channel 7
exceeds the range of inputs
which can be received by the
hardware. (The ERROR LED
indicator is OFF.)
Check the module parameter in HWCONFIG.
Check whether the signal received by channel 7 exceeds
the range of inputs which can be received by the
hardware.