D 11 3
2 Controls
2.1 Operating panel
A
All detent switch functions which may pose a risk on starting the diesel engine are set
to the STOP function in the event of an EMERGENCY STOP or on restarting the con-
trol system. If settings are changed when the diesel engine is stopped ("AUTO" or
"MANUAL"), these are reset to "STOP" on starting the diesel engine.
The "Turning on the spot" function is reset to "Straight-ahead travel".
f
Only adjust the operating panel position whilst the vehicle is stationary!
m
Make sure it is latched properly!
To Next Page
Loading...