Dynapac MF2500CS - Guide rails (7)

F 30 29
Guide rails (7)
A
There are 4 wear rails (A) at the hopper
and 3 wear rails (B) at the conveyor belt
end piece.
A
Check wear at the prescribed intervals and every time that the belt is changed.
A
The guide rails (A) / (B) must be re-
placed at the latest when the wear limit
of 7 mm is no longer achieved in the
marked areas (C).
m
If the guide rails have to be replaced, this
always has to happen in complete sets.
A
Your Dynapac customer service will be
happy to provide support during mainte-
nance, repair and the replacement of
wearing parts!
B
A
C