F 30 17
Move scraper into working position before starting work,
carry out function test/adjust distance
- Move scraper into working position:
- Raise scraper with mounting lever (C).
- Swivel adjusting screw (E) into related groove of scraper tube.
- Relieve mounting lever and remove.
- Insert spring cotter pin (B) properly.
- Repeat process on other side.
- Exit danger area and carry out test run:
Visually check whether all scraper blades are in permanent contact with belt while
conveyor belt is running.
Carry out a complete belt circulation when doing so.
- If necessary, switch off conveyor belt and retension adjusting screws (D) on both
sides in steps of 0.5 rotations.
A
Locking pin (G) must be raised for adjustment.
- Repeat process until correct setting is achieved.
- Spray scraper with separator fluid again if necessary.
To Next Page
Loading...