D 41 23
Loading/conveying material
m
To convey material, the feeder must be in the correct transfer position in front of the
paver finisher.
- Function (65) must be switched off.
- Set the main conveyor belt to the required transfer height using buttons
(47)/(48) (o).
- Set the slewing conveyor belt (o) to the required transfer height using buttons
(45)/(46) and (43/(44) and set-up the transfer position.
m
MF2500CS: For joint use of slewing conveyor belt (o) and height-adjustable main
conveyor belt (o), the main conveyor belt must be set up to its lowest position!
- Use switch (36)/(37) to open the hopper. Instruct the truck driver to dump
the material.
- Switch the conveyor belt functions (51) to "AUTO".
- Activate function (63) to fill the vehicle for the paving process. The paver finisher
hopper is now filled to the set height.
- If necessary, regulate the output of the main conveyor belt and the slewing convey-
or (o) using buttons (49)/(50).
A
If necessary, adjust material height scanning at the ultrasonic sensor (A).
To Next Page
Loading...