F 32 24
Guide rails (7)
A
There are 3 wear rails (A) at the convey-
or belt end piece.
A
Check wear at the prescribed intervals
and every time that the belt is changed.
A
The guide rails (A) must be replaced at
the latest when the wear limit of 7 mm is
no longer achieved in the marked
areas (B).
m
If the guide rails have to be replaced, this
always has to happen in complete sets.
A
Your Dynapac customer service will be
happy to provide support during mainte-
nance, repair and the replacement of
wearing parts!
To Next Page
Loading...