EasyManua.ls Logo

Dynapac MF2500CS - Starting the vehicle

Dynapac MF2500CS
626 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
D 41 6
1.1 Starting the vehicle
Before starting the vehicle
The following must be carried out before the diesel engine can be started and the ve-
hicle can be operated:
- Daily maintenance of the vehicle (see chapter F).
m
Check the operating hours counter to determine whether further maintenance work
should be conducted.
- Check the safety devices and protective devices.
"Normal" starting
- Set the drive lever (13) to the centre position and the travel drive preselector (15)
to minimum.
- Insert the ignition key (11) in position "0".
m
The lights should be switched off during starting to reduce the current drain
on the battery.
A
It is impossible to start the vehicle if an emergency stop button (10) / (100, 108)
is pressed. (Error shown on the display)
- Press the starter button (12) to start the engine. Run the starter continuously for
a maximum of 20 seconds, then take a break for 2 minutes!

Table of Contents