F 32 11
Check conveyor belt frame
for deposits, clean (2)
f
Perform inspection, cleaning and repairs
only whilst the drive engine is stationary!
A
Material deposits in the frame of the
conveyor belt can cause subsequent
damage!
A
There are maintenance flaps under-
neath the frame and at the rear reversal.
- Loosen wind bolts (A) and open all
flaps (B).
- Remove material deposits,
possibly spray the surfaces with sepa-
rator fluid.
- Close all maintenance flaps again cor-
rectly.
f
All maintenance flaps must be closed
during operation!
To Next Page
Loading...