F 30 10
Check conveyor belt for damage
and soiling
f
Perform inspection, cleaning and repairs
only whilst the drive engine is stationary!
A
If discovered early on, conveyor belt damage can be repaired permanently!
A
The conveyor belt can be accessed
through the open maintenance flap (A)
for maintenance work.
f
Keep the maintenance flap closed dur-
ing operation; never open whilst the con-
veyor belt is running!
- To inspect it, lower the conveyor belt
and secure the conveyor belt drive to
prevent reactivation.
- Gradually move and check the convey-
or belt using the lateral operating unit.
A
Check the entire conveyor belt (B) for
the following defects:
- Cracks, breakage and wear on the
surface and at the sides.
- Missing or loose assembly parts.
- Wear, damage and soiling on the drive chains and chain sprockets.
A
If necessary, remove covers (C) to check the conveyor belt.
- Remove encrusted material from the sealing plates (D).
A
Your Dynapac customer service will be happy to provide support during maintenance,
repair and the replacement of wearing parts!
To Next Page
Loading...