EasyManua.ls Logo

Dynapac MF2500CS - Observe indicator lamps; Engine coolant temperature check (A); Battery charge indicator lamp (B); Diesel engine oil pressure indicator lamp (C)

Dynapac MF2500CS
626 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
D 41 13
Observe indicator lamps
The following indicator lamps must be observed under all circumstances:
For other possible errors, see engine's operating instructions.
Engine coolant temperature check (A)
Lights up when the engine temperature is outside of the permissible range.
m
Stop the vehicle (drive lever in centre position), let the engine cool down while idling.
Determine the cause and correct it if necessary.
A
The engine performance will be throttled down automatically. (Driving mode remains
possible). After cooling down to normal temperature, the engine will run with full per-
formance again.
Battery charge indicator lamp (B)
Must go out after starting when the engine revs up.
m
If the lamp does not go out or lights up during operation: Briefly rev up the engine.
Switch off the engine and determine the fault if the lamp does not go out.
For further possible malfunctions, refer to the section "Malfunctions".
Diesel engine oil pressure indicator lamp (C)
Must go out 15 seconds after starting at the latest.
m
If the lamp does not go out or lights up during operation: switch off engine immediately
and determine fault.

Table of Contents