D 41 15
Travel drive oil pressure indicator lamp (D)
- Must go out after starting.
m
If the lamp does not go out:Do not switch on the travel drive! Otherwise, the entire
hydraulic system could be damaged.
- Activate set-up mode function (64).
- Set conveyor belt functions (52) or (63) to "manual". The conveyor belts start
to operate
- Let the hydraulics warm up until the indicator lamp goes out.
A
The Lamp goes out when the pressure drops below 2.8 bar = 40 psi.
For further possible faults, refer to the section "Malfunctions".
To Next Page
Loading...