F 30 12
Emulsion spraying system (2)
A
The spraying bar (A) installed above the
conveyor belt is engaged on activation
of the conveying function.
- Check the filling level using the dis-
play on the operating panel.
A
Increased emulsion consumption due to
use of the manual spray.
To top up the tank:
- Remove cap (B).
- Fill in emulsion through the filler open-
ing until the required filling level
is achieved.
- Screw cap (B) on again.
f
Refill the tank only whilst the vehicle
is stationary!
m
Only operate the spraying system with
approved emulsion!
To Next Page
Loading...