Dynapac MF2500CS - Check the tension of the drive chains (6)

F 95 10
Check the tension of
the drive chains (6)
- Remove the protective hood (A)
of the auger drive.
To check the chain tension:
- When the tension is set correctly,
the chain must be able to move freely
approx. 10 mm.
To re-tension the chains
- Unfasten mounting screws (B) and
lock nut (C) slightly.
- Adjust the required chain tension us-
ing the tensioning screw (C).
- Retighten fastening bolts (B) and lock
nuts (C) correctly.
- Regrease the chain with a suitable
grease.
- Then put the protective hood (A) back
in the proper position.
A
B
B
C
D
1
0
mm