F 30 13
Central lubrication system (3)
Danger of injuries!
f
Do not reach into the tank when the
pump is running!
f
The central lubrication system must
only be operated with the safety valve
installed!
f
Do not undertake any work on parts of
the system during operation!
f
Ensure that the diesel engine cannot be
started when working on the system!
f
Observe safety regulations for handling hydraulic systems!
m
Ensure maximum cleanliness when working on the central lubrication system!
Central lubrication system
Check filling level
m
The lubricant tank should always be
filled sufficiently to ensure that the sys-
tem cannot "run dry" and that sufficient
drive chain lubrication is ensured.
To top up with lubricant:
- Top up the tank to the "MAX" mark be-
fore starting work or on receipt of an
electronic empty message.
- Release and pull off connector (A).
- Unscrew tank cap (B).
- Top the tank up to the "MAX" mark
with the specified oil.
- Screw on the tank cap (B) again and position the connector properly.
To Next Page
Loading...