E 1
E Set-up and modification
1 Special safety instructions
f
Danger to personnel by inadvertent starting of the engine, travel drive, conveyor belt,
raising or slewing equipment.
Unless otherwise specified, work may only be performed when the engine is
at a standstill!
- Secure the vehicle to prevent it from being started accidentally:
Move drive lever into centre position and turn preselector controller to zero, remove
ignition key and battery main switch.
- Secure raised vehicle parts (e.g. control platform, conveyor belt or hopper) with me-
chanical safeguards to prevent them from being lowered.
- Replace parts or have them replaced as stipulated.
f
When connecting or disconnecting hydraulic hoses and when working on the hydrau-
lic system, hot hydraulic fluid may spurt out at high pressure.
Switch off the engine and depressurise the hydraulic system! Protect your eyes!
- Mount all protective devices before re-commissioning the feeder.
Danger due to changes at the vehicle
Structural chances to the vehicle make the operating
licence null and void and can cause severe to fatal injuries!
- Only use original spare parts and approved accessories.
- After maintenance and repair work, ensure that any dis-
mantled protective and safety devices are all completely
fitted again.
- Comply with all further information in these instructions
and in the safety manual.
To Next Page
Loading...