D 11 7
m
When fitted with SW6500:
Every time after restarting the vehicle, the main conveyor has to be moved into its up-
per end position when starting up the conveying function for the first time or when ac-
tuating functions (43-46) / (131-134)!
Function buttons (47) and (48) are then deactivated until the next restart.
Item Designation Brief description
13
Drive lever
(traction)
For engaging the feeder functions and continuously regulating
the vehicle speed – forward or reverse.
Centre position: Engine in neutral; no travel drive;
- To swivel the drive lever out, release by pulling the handle up.
- Engagement of the conveying functions
set to "AUTO"!
A
Use the preselector to set the maximum speed.
f
The vehicle speed cannot be reduced to "0" with the
preselector. The vehicle advances slightly with deflec-
ted drive lever, even if the travel drive preselector is set
to zero!
A
If the engine is started with the drive lever swivelled, the
travel drive is blocked.
To be able to start the travel drive, the drive lever must
first be returned to the centre position.
A
When changing over between forwards and reverse tra-
vel, the drive lever must remain briefly in neutral.
To Next Page
Loading...