EasyManua.ls Logo

Dynapac MF2500CS - Page 307

Dynapac MF2500CS
626 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
D 41 9
- If necessary, start the engine of the vehicle supplying power and leave to run
for a while.
Now try to start the other vehicle:
- Press the starter button (12) to start the engine. Run the starter continuously for
a maximum of 20 seconds, then take a break for 2 minutes!
- If the engine still has not started after two attempts, ascertain the cause!
- If the engine starts up: disconnect the starting aid cable again in reverse order.

Table of Contents