B 7
Steering system/operator's platform: The independent hydrostatic travel drives al-
low the feeder to be turned on the spot.
Electronic synchronous control ensures precise straight-ahead travel.
The hydraulically height-adjustable control platform (o) provides the driver with an
optimal view of all necessary working areas.
The driver's seats and the operating panel can be swivelled for operation beyond the
outer edge of the vehicle.
Push roller crossbar: The push rollers for material trucks are fastened to a crossbar
that is pivoted at its centre. The feeder deviates less from its course and material
transfer in curves is made easier.
For adaptation to various truck design types, the push roller crossbar can be shifted
to two positions.
Material compartment (hopper): The hopper inlet is equipped with a conveyor sys-
tem for emptying and transporting the material onwards.
The hopper can hold approx. 12.0 t.
To facilitate emptying and achieve even material transfer, each of the lateral covers
of the hopper can be hydraulically folded in.
The hydraulic front hopper flaps ensure that no material remains in the front area of
the hoppers.
Conveyor belt: The feeder is equipped with a rubber conveyor belt for material
transfer. The hydrostatic drive is continuously adjustable.
The transfer amount or speed is regulated fully automatically by scanning the
filling height.
A scraper is located in the ejection area for cleaning and to reduce wear.
An automatic chain lubricating system keeps the drive chains constantly lubricated.
Height-adjustable conveyor belt (o): A height-adjustable conveyor belt is available
tor adjusting to different types of material compartment.
To Next Page
Loading...