F 11 2
Hot surfaces!
Surfaces including those behind covering parts, together
with engine combustion gases can be very hot and
cause injuries!
- Wear your personal safety gear.
- Do not touch hot parts of the vehicle.
- Only perform maintenance and repair work after the
vehicle has cooled down.
- Comply with all further information in these instructions
and in the safety manual.
Danger due to electric shock
Injuries can be caused by touching live parts directly
or indirectly!
- Do not remove any protective safeguards.
- Never spray water on electric or electronic components.
- Maintenance work to the electric system should only be
carried out by trained specialist staff.
- Comply with all further information in these instructions
and in the safety manual.
Danger from heavy loads
Lowering vehicle parts may cause injuries!
- When the vehicle is parked and during maintenance and
transport, close both hopper lids and fit the correspond
-
ing hopper transport safeguards.
- When the vehicle is parked and during maintenance and
transport, secure the conveyor belt mechanically to pre
-
vent lowering.
- Ensure that opened hoods and covering parts are
locked properly.
- Comply with all further information in these instructions
and in the safety manual.
To Next Page
Loading...