F 32 2
Danger of being pulled in by rotating or conveying
vehicle parts
Rotating or conveying vehicle parts can cause severe
or fatal injuries!
- Do not enter the danger zone.
- Do not reach into rotating or conveying parts.
- Only wear close-fitting clothing.
- Comply with the warning and information signs
on the vehicle.
- Stop the engine and remove the ignition key before any
maintenance work.
- Comply with all further information in these instructions
and in the safety manual.
Danger from heavy loads
The raised machine can slide away and cause severe
to fatal injuries!
- The vehicle may only be raised at the marked
lifting points.
- Heed the operating weight of the vehicle.
- Do not enter the danger zone.
- Only use approved ramps and adequately dimensioned
ramps or pits.
- Use only lifting gear that can bear the load.
- Do not leave any load or loose parts on the vehicle.
- Comply with all further information in these instructions
and in the safety manual.
Hot surfaces!
Surfaces including those behind covering parts,
together with engine combustion gases can be very hot
and cause injuries!
- Wear your personal safety gear.
- Do not touch hot parts of the vehicle.
- Only perform maintenance and repair work after the
vehicle has cooled down.
- Comply with all further information in these instructions
and in the safety manual.
To Next Page
Loading...