F 52 24
- Lightly grease the O-ring (H) of the
multi-head.
- Fold the filter element (G) in the middle
towards the underside of the lower part.
- Tilt the lower part at an angle of
about 45°.
- Place the filter side and the tip of the
lower part in the tank opening as
shown.
- Gradually insert the lower part in the
tank opening, proceeding carefully.
m
Do not push the parts with force directly
into the tank opening. This will cause
damage!
- Position the head in the required align-
ment and press on the top until the head
fits completely in the tank opening.
To Next Page
Loading...