Dynon Avionics SkyView HDX - Page 251

Messages and Alerts
SkyView HDX Pilot’s User Guide – Revision B 12-9
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Caution”
CPU TEMP CRITICAL
The display internal temperature
is high. To prevent permanent
damage, the display may shut
down at any time unless
immediate action is taken to cool
it down.
“Caution”
ROTAX: LIMIT
FLIGHT OP
The ROTAX engine has informed
SkyView there is a problem with
the engine.
“Caution”
ROTAX: LAND
AIRCRAFT
The ROTAX engine has informed
the SkyView EMS-221 there is a
significant problem with the
engine.
“Switch Fuel Tank”
SWITCH FUEL TANK
The optionally-configured fuel
tank timer has reached its pre-
configured time or fuel quantity
consumption limit.
“Timer Expired”
TIMER EXPIRED
A DOWN timer under TOOLS >
TIMER has expired.
“Message”
EXT LEVEL BUTTON
STUCK
The external Level Button is stuck
and is inoperative.
“Message”
CHECK BARO
SETTING
The current BARO setting and the
nearest METAR-based altimeter
setting are more than .1 inHg
apart. Or the aircraft has
descended below FL180 and the
BARO should be reset.
“Message”
BATTERY TEST
FAILED
A full backup battery test was
performed, and it failed. See the
Installation Guide for further
troubleshooting information.
“Message”
BATTERY TEST
NEEDED
A year or more has passed since
the last successful backup battery
test, or the last three SkyView
shutdowns were abnormal.
“Message”
SOFTWARE
MISMATCH
SkyView components are not all
running the same firmware
version
“Message”
OEM CONFIG
MISMATCH
OEM-customized displays are not
in sync with each other