Dynon Avionics SkyView HDX - Page 252

Messages and Alerts
12-10 SkyView HDX Pilot’s User Guide – Revision B
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Message”
TAIL # MISMATCH
Tail numbers differ between
SkyView displays – settings will
not properly synchronize
“Message”
XPNDR NOT IN ALT
MODE
The aircraft is in flight and the
Transponder is not in Alt Mode
“Message”
CPU TEMP HIGH
The display internal temperature
is significantly higher than the
normal operating temperature.
“Message”
BACKUP BATT LOW
CHARGE
The backup battery connected to
this display is not charged.
“Message”
Wi-Fi Offline
The Wi-Fi Adapter is currently
offline.
“Message”
SYSTEM EVENT n
SkyView has detected a possible
problem with software or
hardware. Please fill out form at
http://dynon.aero/event5 when
convenient.
“Message”
XPNDR WARNING
MESSAGE
The transponder has detected a
problem and notified SkyView.
See the SETUP MENU for the
specific problem.
“Gees” (repeats)
None
n/a
The G meter is in the yellow
caution range
“Over Gees” (repeats)
None
n/a
The G meter is in the red warning
range
“Traffic Not Available”
None
n/a
Traffic is not available from a
previously available source
“Traffic”
None
n/a
A new traffic advisory target has
been identified. Note that this
audio alert is suppressed when
not in flight to reduce nuisance
alerts. Other visual traffic alert
indications persist, however.
“Autopilot”
None
n/a
The roll or pitch autopilot axis has
been engaged
“Autopilot Mode”
None
n/a
The autopilot roll mode has
changed since it was engaged.
This includes sequencing onto an
armed mode (such as an ALT Hold
> VNAV sequence)