Dynon Avionics SkyView HDX - Page 253

Messages and Alerts
SkyView HDX Pilot’s User Guide – Revision B 12-11
Spoken Alert (if
configured)
Message Displayed
in Message
Window
Notification
Area Alert
(severity)
Description
“Autopilot Disconnect”
None
n/a
The roll or pitch autopilot axis has
disconnected
“Go Around”
None
n/a
The autopilot go around function
has been engaged.
“Trim Up”
None
n/a
The autopilot requires nose up
trim to maintain control of the
aircraft, and has been
annunciating this visually on the
display for at least 30 seconds.
This alert is played a maximum of
once every 30 seconds.
“Trim Down”
None
n/a
The autopilot requires nose down
trim to maintain control of the
aircraft, and has been
annunciating this visually on the
display for at least 30 seconds.
This alert is played a maximum of
once every 30 seconds.
“Autopilot Airspeed
High/Low”
None
n/a
The autopilot airspeed limits are
exceeded.
“Approaching Minimums”
None
n/a
Altitude is within 200 feet of the
MDA bug
“Minimums”
None
n/a
Aircraft has descended below
MDA bug
“Approaching Altitude” /
“Leaving Altitude”
None
n/a
Altitude alerter notification that
the aircraft is approaching or
leaving the bugged altitude
“Overspeed”
None
n/a
Indicated airspeed is exceeding
Vne
“Flaps Overspeed”
None
n/a
Indicated airspeed is exceeding
Vfe (and flaps are at least partially
deployed)
“Flight Plan Updated”
None
n/a
A new flight plan has been
received by SkyView from an
external flight plan source (such
as ForeFlight)
“Approaching Waypoint”
None
n/a
The aircraft is within 30 seconds
of an upcoming SkyView flight
plan waypoint (except the final
waypoint)