C
HAPTER
41
| OAM Commands
– 1005 –
efm oam mode This command sets the OAM mode on the specified port. Use the no form
to restore the default setting.
SYNTAX
efm oam mode {active | passive}
no efm oam mode
active - All OAM functions are enabled.
passive - All OAM functions are enabled, except for OAM discovery,
and sending loopback control OAMPDUs.
DEFAULT SETTING
Active
COMMAND MODE
Interface Configuration
COMMAND USAGE
When set to active mode, the selected interface will initiate the OAM
discovery process. When in passive mode, it can only respond to discovery
messages.
EXAMPLE
Console(config)#interface ethernet 1/1
Console(config-if)#efm oam mode active
Console(config-if)#
clear efm oam
counters
This command clears statistical counters for various OAMPDU message
types.
SYNTAX
clear efm oam counters [interface-list]
interface-list - unit/port
unit - Unit identifier. (Range: 1)
port - Port number or list of ports. To enter a list, separate
nonconsecutive port identifiers with a comma and no spaces;
use a hyphen to designate a range of ports. (Range: 1-10)
COMMAND MODE
Privileged Exec
EXAMPLE
Console#clear efm oam counters
Console#
To Next Page
Loading...
Need help?
General