C
HAPTER
35
| VLAN Commands
Configuring VLAN Interfaces
– 833 –
interface vlan This command enters interface configuration mode for VLANs, which is
used to configure VLAN parameters for a physical interface.
SYNTAX
[no] interface vlan vlan-id
vlan-id - ID of the configured VLAN. (Range: 1-4093, no leading
zeroes)
DEFAULT SETTING
None
COMMAND MODE
Global Configuration
EXAMPLE
The following example shows how to set the interface configuration mode
to VLAN 1, and then assign an IP address to the VLAN:
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
RELATED COMMANDS
shutdown (725)
interface (720)
vlan (831)
switchport ingress-
filtering
Enables ingress filtering on an interface IC
switchport mode Configures VLAN membership mode for an interface IC
switchport native vlan Configures the PVID (native VLAN) of an interface IC
switchport priority default Sets a port priority for incoming untagged frames IC
vlan-trunking Allows unknown VLANs to cross the switch IC
Table 112: Commands for Configuring VLAN Interfaces (Continued)
Command Function Mode
To Next Page
Loading...
Need help?
General