C
HAPTER
27
| Interface Commands
– 731 –
show interfaces
status
This command displays the status for an interface.
SYNTAX
show interfaces status [interface]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-10)
port-channel channel-id (Range: 1-5)
vlan vlan-id (Range: 1-4093)
DEFAULT SETTING
Shows the status for all interfaces.
COMMAND MODE
Normal Exec, Privileged Exec
COMMAND USAGE
If no interface is specified, information on all interfaces is displayed. For a
description of the items displayed by this command, see "Displaying
Connection Status" on page 131.
EXAMPLE
Console#show interfaces status ethernet 1/1
Information of Eth 1/1
Basic Information:
Port Type : 100TX
MAC Address : 00-E0-0C-00-00-FE
Configuration:
Name :
Port Admin : Up
Speed-duplex : Auto
Capabilities : 10half, 10full, 100half, 100full
Broadcast Storm : Enabled
Broadcast Storm Limit : 500 packets/second
Multicast Storm : Disabled
Multicast Storm Limit : 64 Kbits/second
Unknown Unicast Storm : Disabled
Unknown Unicast Storm Limit : 64 Kbits/second
Flow Control : Disabled
VLAN Trunking : Disabled
LACP : Disabled
Port Security : Disabled
Max MAC Count : 0
Port Security Action : None
Media Type : Copper forced
Current Status:
Link Status : Up
Port Operation Status : Up
Operation Speed-duplex : 100full
Flow Control Type : None
Console#
To Next Page
Loading...
Need help?
General