C
HAPTER
38
| Multicast Filtering Commands
Multicast VLAN Registration
– 930 –
The following displays information about the interfaces attached to the
MVR VLAN:
Console#show mvr interface
Port Type Status Immediate Static Group Address
-------- -------- ------------- --------- --------------------
Eth1/ 2 Source Active/Up
Eth1/ 3 Source Inactive/Down
Eth1/ 1 Receiver Active/Up Disabled 225.0.0.1(VLAN1)
225.0.0.9(VLAN3)
Eth1/ 4 Receiver Active/Down Disabled
Console#
Table 132: show mvr - display description
Field Description
MVR Config Status Shows if MVR is globally enabled on the switch.
MVR Running Status Indicates whether or not all necessary conditions in the MVR
environment are satisfied. (Running status is true as long as MVR
Status is enabled, and the specified MVR VLAN exists.)
MVR Multicast VLAN Shows the VLAN used to transport all MVR multicast traffic.
MVR Current Learned
Groups
The current number of MVR group addresses
MVR Forwarding Priority Priority assigned to multicast traffic forwarded into the MVR VLAN
MVR Upstream Source IP The source IP address assigned to all upstream control packets.
MVR Group Range The multicast group addresses configured for this switch
Table 133: show mvr interface - display description
Field Description
Port Shows interfaces attached to the MVR.
Type Shows the MVR port type.
Status Shows the MVR status and interface status. MVR status for source
ports is “ACTIVE” if MVR is globally enabled on the switch. MVR
status for receiver ports is “ACTIVE” only if there are subscribers
receiving multicast traffic from one of the MVR groups, or a
multicast group has been statically assigned to an interface.
Immediate Leave Shows if immediate leave is enabled or disabled.
Static Group Address Shows any static MVR group assigned to an interface, and the
receiver VLAN.
To Next Page
Loading...
Need help?
General