C
HAPTER
15
| Basic Administration Protocols
Simple Network Management Protocol
– 391 –
To show the OID branches configured for the SNMP views of the switch’s
MIB database:
1. Click Administration, SNMP.
2. Select Configure View from the Step list.
3. Select Show OID Subtree from the Action list.
4. Select a view name from the list of existing views.
Figure 224: Showing the OID Subtree Configured for SNMP Views
CONFIGURING
SNMPV3 GROUPS
Use the Administration > SNMP (Configure Group) page to add an SNMPv3
group which can be used to set the access policy for its assigned users,
restricting them to specific read, write, and notify views. You can use the
pre-defined default groups or create new groups to map a set of SNMP
users to SNMP views.
CLI REFERENCES
â—† "show snmp group" on page 582
PARAMETERS
These parameters are displayed:
◆ Group Name – The name of the SNMP group to which the user is
assigned. (Range: 1-32 characters)
◆ Security Model – The user security model; SNMP v1, v2c or v3.
◆ Security Level – The following security levels are only used for the
groups assigned to the SNMP security model:
â–
noAuthNoPriv – There is no authentication or encryption used in
SNMP communications. (This is the default security level.)
â–
AuthNoPriv – SNMP communications use authentication, but the
data is not encrypted.
â–
AuthPriv – SNMP communications use both authentication and
encryption.
To Next Page
Loading...
Need help?
General